DEVELOP Training Center menyelenggarakan Kelas Structural Connection Design for Modular Process Plant Assembly yang sangat berguna untuk mendapatkan pengetahuan tentang desain sambungan struktur untuk perakitan pabrik proses modular, mencakup transfer beban, baut, las, splice, toleransi, erection, bracing sementara, dan inspeksi sambungan.
Pelatihan dilaksanakan melalui penyampaian materi dan diskusi interaktif di dalam kelas. Peserta pelatihan diajak untuk sepenuhnya aktif dalam memahami materi yang disampaikan oleh instruktur.

Sesi 1-2
- Structural connection requirements for modular process plant assembly
- Module framing configuration and connection locations
- Bolted and welded connection selection
- Member forces at modular structural joints
- Connection load paths and force transfer
- Column splice and beam connection arrangements
- Module-to-module structural connection interfaces
- Temporary connection requirements during assembly
- Fabrication tolerances and erection clearances
- Connection access for bolting and welding
- Equipment and piping interface constraints
- Case Study
Sesi 3-4
- Bolt tension, shear, and combined load checks
- Weld capacity and connection geometry assessment
- Plate thickness and local bearing checks
- Block shear and net section resistance
- Column splice force transfer requirements
- Moment connection behavior for modular frames
- Connection deformation and structural alignment
- Temporary erection bracing and stability
- Module transportation connection requirements
- Site assembly sequence and connection inspection
- Dimensional verification and field adjustment details
- Preparation of modular connection drawings and calculations
- Case Study
Sejalan dengan teori yang disampaikan,sebanyak mungkin akan diberikan contoh-contoh studi kasus yang relevan dengan kondisi yang ada diindustri. Dalam hal ini peserta diberikan kesempatan untuk bertanya dan mendiskusikan topik-topik yang dibahas.
