DEVELOP Training Center menyelenggarakan Kelas Generator Set Engine Control Link Installation Inspection and Maintenance Training yang sangat berguna untuk mendapatkan pengetahuan tentang engine control link genset, governor, throttle actuator, link rod, joint, spring, alignment, free movement, keausan, penyetelan, inspeksi, pemeliharaan, dan respons putaran mesin.
Pelatihan dilakukan dengan cara menyampaikan materi dan melakukan diskusi interaktif di kelas. Peserta pelatihan didorong untuk berperan aktif dalam memahami materi yang diberikan oleh instruktur.

Sesi 1-2
- Engine control linkage system architecture
- Mechanical linkage components and connection points
- Governor interface and engine speed control
- Throttle actuator and control lever arrangement
- Link rods, joints, springs, and brackets
- Linkage movement and operating range
- Control lever position and engine response
- Mechanical clearance and free movement requirements
- Linkage wear, corrosion, and deformation
- Control system vibration and connection security
- Relationship between linkage position and engine speed
- Case Study
Sesi 3-4
- Control link installation and alignment inspection
- Link rod length and position verification
- Joint and pivot condition assessment
- Spring and bracket inspection
- Control lever movement testing
- Governor linkage connection verification
- Throttle response and engine speed testing
- Linkage lubrication and wear assessment
- Binding and excessive movement diagnosis
- Adjustment of mechanical linkage position
- Maintenance records and inspection documentation
- Final engine control response verification
- Case Study
Sejalan dengan teori yang disampaikan, sebanyak mungkin akan disertakan contoh-contoh studi kasus yang relevan dengan kondisi aktual di industri. Peserta juga diberikan kesempatan untuk mengajukan pertanyaan dan mendiskusikan topik-topik yang dibahas.
